Vibesware GR-1 Manual de usuario descargar pdf (Pagina 12)

5 Frequently asked questions and troubleshooting

Problem Solution

The light intensity at the

Resonator Head is poor and

the string agitation is weak

The guitar gain or Resonator gain is to low.

Another reason might be that pickup tone

control cuts the high frequencies which

downgrades the string agitation particular on

higher strings.

Pickup wheezing / impure tone

caused by magnetic

interference to the pickup(s)

The distance between the selected pickup and

the Resonator Head is too small or the gain of

the Resonator Box is too high. Single coils are

more sensitive than humbuckers. The

sensitivity also depends a little bit on the phase

setting. In most cases it is possible to find a

gain setting where the overall neck area can be

played.

Another possible reason might be that there is

another effect placed between the guitar and

the Resonator box. In general, effect boxes

should be connected after the Guitar

Resonator.

I am used to play with reduced

guitar pickup gain and would

like to use the Resonator also

with this setting.

As a simple solution, you could use a volume

pedal after the Resonator. If you dont want this,

there is another workaround: Try to split the

guitar signal with a splitter box. One signal goes

to the amplifier and the other goes to a

compressor/Sustainer pedal and then to the

Resonator. By this the Resonator gets a

stronger signal. If the sensitibity at turned up

guitar volume becomes too high, the

compressor pedal can be bypassed

1 2 ... 7 8 9 10 11 12

Sin comentarios

Vibesware GR-1 Manual de usuario Pagina 12