Vibesware GR-1 Manual de usuario descargar pdf (Pagina 14)

5 Frequently asked questions and troubleshooting

Problem possible reason / corrective or

workaround

The phase shifting does not

work and there is only one

LED color at the Resonator

head.

Resonator Box and Head are not connected

with a stereo cable

The light intensity at the

Resonator Head is poor and

the string agitation is weak

The guitar gain or Resonator gain is to low.

Another reason might be that pickup tone

control cuts the high frequencies which

downgrades the string agitation particular on

higher strings.

Pickup wheezing / impure

tone caused by magnetic

interference to the pickup(s)

The distance between the selected pickup

and the Resonator Head is too small or the

gain of the Resonator Box is too high. Single

coils are more sensitive than humbuckers.

The sensitivity also depends a little bit on the

phase setting. In most cases it is possible to

find a gain setting where the overall neck

area can be played with the bridge pickup.

With the neck pickup playing up to the 12

th

fret should be possible.

Another possible reason might be that there

is another effect placed between the guitar

and the Resonator box. In general, effect

boxes should be connected after the Guitar

Resonator.

I am used to play with

reduced guitar pickup gain

and would like to use the

Resonator also with this

setting.

As a simple solution, you could use a volume

pedal after the Resonator. If you dont want

this, there is another workaround: Try to split

the guitar signal with a splitter box. One

signal goes to the amplifier and the other

goes to a compressor/Sustainer pedal and

then to the Resonator box. By this the

Resonator gets a stronger signal. If the

sensitibity at turned up guitar volume

becomes too high, the compressor pedal can

be bypassed.

12

1 2 ... 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios